AKAG TOY

M1 Aluminum Alloy Red Dot Sight Four-Point Upgrade Accessories

$48.99 USD

Sale Sold out

Shipping calculated at checkout.

colour black green gray orange red sand rose gold

Quantity

Description:
-The Optics M1 is a non-magnified, open-fire reflex sight with a 3-MOA red dot for a wider field of view and faster target acquisition.

-The topless design provides a wider field of view, faster target acquisition, and more accurate shooting.

-Rubber buttons allow for easy brightness adjustment and customization of windage and elevation within a 50 MOA range.

-Compatible with multiple platforms and easy to install. The battery compartment is accessible from the top of the housing, allowing batteries to be replaced without removing the sight from the firearm.

Specifications:
Magnification: 1X
Lens Diameter: 24mm
Waterproof Rating: IPX7
Lighting Settings: 10, including 2 night settings
Run Time: 10,000 hours
Battery Type: 1 CR1632 battery

Packing List: 1 * M1 Red Dot Sight

We promise

We offer free shipping and tax exemption worldwide. If you are unable to pay or have questions about the payment amount, please contact us.
If the product or accessory you want to buy is not shown on our website, please send us a message and we will solve it for you as soon as possible.
Secure payment via Stripe or PayPal.
We use encrypted SSL certificates to ensure 100% security.
Customer service responds to messages 24 hours a day.
30-day money back guarantee.
If you do not have a pleasant shopping experience, please contact us at service@akagtoy.com, we will provide you with satisfactory service and make you 100% satisfied.

Gel Ball Preparation and Use

Soaking Requirements: It is best to use purified water, and sufficient water is essential. Impure water will cause the gel balls to shrink, which can result in reduced range or even inability to shoot.
Soaking Time: Soak the gel balls for 4-6 hours to ensure full expansion.
How to Use: Before loading the gel ball into the magazine, drain the water first to prevent moisture from damaging the circuit.
Storage: After soaking, drain the water and store them tightly sealed. Gel balls that have been soaked for too long or not properly can break or get stuck, making them inoperable.
7-8mm super-hard frosted balls are best for electric pistol toys; other sizes break easily.
Standard Size: 7.15mm - 7.3mm (fits most gel blasters).

Battery Safety and Usage

When using a battery for the first time, fully charge it. Do not charge the battery through the discharge port.
Use a charger with a voltage balancing function to charge the device.
If you notice a drop in power during use, discontinue use. Leave approximately 10% of the battery charge in the battery. Do not drain the battery completely to avoid damage caused by over-discharge.
For gel blasters with electronic speed control or fire control, remove the battery after use to avoid permanent damage.
The 7.4V battery consists of two cells, and the 11.1V battery consists of three cells. The voltage of a single cell should not be lower than 3.3V or higher than 4.2V. Store the device between 3.8-3.9V for extended periods.
Overheating of the motor may cause the battery to expand or even ignite. Please inspect your device carefully and use with caution. Do not use the battery if it is damaged or bulging.
If the battery does not fully charge after a long period of time, use a baby ring to check the voltage of each cell.
Remove the battery when not in use to extend the life of the transmitter.