AKAG TOY

MG3 Electric Shell Ejection Soft Bullet Gun-Children's Toy Gun

$79.99 USD

Sale Sold out

Taxes included. Shipping calculated at checkout.

colour camouflage 30*shells+80*soft bullets

Description:
-It uses a belt to feed ammunition, and there is a drum on the left side for storing the belt, which has a high degree of restoration. An extended belt can be installed to increase the number of spare ammunition.

-Three shooting modes: electric burst, electric single shot and manual single shot. Switch to manual single shot, no need to load, just pull the bolt to load and shoot, experience the real loading experience. Electric burst, no need to load, just pull the trigger to shoot continuously.

-The tripod can be adjusted to multiple angles by rotating up and down, left and right, and the bottom is equipped with a suction cup, which can be firmly attached to the smooth ground. It is also equipped with two crosshairs, conventional crosshairs and high-altitude crosshairs, suitable for shooting different targets.

-The quadruple mirror can be magnified and reduced, and the front is equipped with a rear scale with adjustable height. The ergonomic buttstock makes shoulder shooting more comfortable.

Features:
1.DIY assembly, belt feeding
2.Built-in battery, EVA soft bullet
3.Shooting mode: manual/semi-automatic/fully automatic
4.Range: 15-20 meters
5.Ammunition type: 4.5*1.3cm or half-length dart
6.Battery type: sm plug 4pin 7.4v8
7.Size: 97 cm

Packing list:
1* MG3 soft bullet gun
1*adjustable zoom lens
1*laser
1*drum magazine
1*goggles
1*triangle bracket
1*shoulder strap
1*rechargeable battery
1*USB charging cable
24*shells
30*soft bullets

We promise

We offer free shipping and tax exemption worldwide. If you are unable to pay or have questions about the payment amount, please contact us.
If the product or accessory you want to buy is not shown on our website, please send us a message and we will solve it for you as soon as possible.
Secure payment via Stripe or PayPal.
We use encrypted SSL certificates to ensure 100% security.
Customer service responds to messages 24 hours a day.
30-day money back guarantee.
If you do not have a pleasant shopping experience, please contact us at service@akagtoy.com, we will provide you with satisfactory service and make you 100% satisfied.

Gel Ball Preparation and Use

Soaking Requirements: It is best to use purified water, and sufficient water is essential. Impure water will cause the gel balls to shrink, which can result in reduced range or even inability to shoot.
Soaking Time: Soak the gel balls for 4-6 hours to ensure full expansion.
How to Use: Before loading the gel ball into the magazine, drain the water first to prevent moisture from damaging the circuit.
Storage: After soaking, drain the water and store them tightly sealed. Gel balls that have been soaked for too long or not properly can break or get stuck, making them inoperable.
7-8mm super-hard frosted balls are best for electric pistol toys; other sizes break easily.
Standard Size: 7.15mm - 7.3mm (fits most gel blasters).

Battery Safety and Usage

When using a battery for the first time, fully charge it. Do not charge the battery through the discharge port.
Use a charger with a voltage balancing function to charge the device.
If you notice a drop in power during use, discontinue use. Leave approximately 10% of the battery charge in the battery. Do not drain the battery completely to avoid damage caused by over-discharge.
For gel blasters with electronic speed control or fire control, remove the battery after use to avoid permanent damage.
The 7.4V battery consists of two cells, and the 11.1V battery consists of three cells. The voltage of a single cell should not be lower than 3.3V or higher than 4.2V. Store the device between 3.8-3.9V for extended periods.
Overheating of the motor may cause the battery to expand or even ignite. Please inspect your device carefully and use with caution. Do not use the battery if it is damaged or bulging.
If the battery does not fully charge after a long period of time, use a baby ring to check the voltage of each cell.
Remove the battery when not in use to extend the life of the transmitter.