SHS AEG Accessories Unequal Distance Spring M85-M190

Description:
Silver steel piano wire, non-linear spring type.

One of our most popular airgun upgrade springs!

Spring made of high quality steel allows your gun to run at speeds below 400 FPS.

Suitable for all standard gearboxes. Great for M4 upgrades, custom guns, etc.

Both ends are ground flat.

Surface is nickel plated for a beautiful and rust-resistant look.

Lifespan: 500,000 times

Types: m85, m90, m95, m100, m110, m120, m130, m140, m150, m160, m170, m180, m190

SHS AEG Spring Power Chart:
M90 - 290-300fps
M100 - 330-350fps
M110 - 350-380 fps
M120 - 380-410fps
M130 - 410-440fps
M140 - 440-470fps
M150 - 470-500fps
M170 - 550-600fps
M190 - 650-700fps

We promise

We offer free shipping and tax exemption worldwide. If you are unable to pay or have questions about the payment amount, please contact us.
If the product or accessory you want to buy is not shown on our website, please send us a message and we will solve it for you as soon as possible.
Secure payment via Stripe or PayPal.
We use encrypted SSL certificates to ensure 100% security.
Customer service responds to messages 24 hours a day.
30-day money back guarantee.
If you do not have a pleasant shopping experience, please contact us at service@akagtoy.com, we will provide you with satisfactory service and make you 100% satisfied.

Gel Ball Preparation and Use

Soaking Requirements: It is best to use purified water, and sufficient water is essential. Impure water will cause the gel balls to shrink, which can result in reduced range or even inability to shoot.
Soaking Time: Soak the gel balls for 4-6 hours to ensure full expansion.
How to Use: Before loading the gel ball into the magazine, drain the water first to prevent moisture from damaging the circuit.
Storage: After soaking, drain the water and store them tightly sealed. Gel balls that have been soaked for too long or not properly can break or get stuck, making them inoperable.
7-8mm super-hard frosted balls are best for electric pistol toys; other sizes break easily.
Standard Size: 7.15mm - 7.3mm (fits most gel blasters).

Battery Safety and Usage

When using a battery for the first time, fully charge it. Do not charge the battery through the discharge port.
Use a charger with a voltage balancing function to charge the device.
If you notice a drop in power during use, discontinue use. Leave approximately 10% of the battery charge in the battery. Do not drain the battery completely to avoid damage caused by over-discharge.
For gel blasters with electronic speed control or fire control, remove the battery after use to avoid permanent damage.
The 7.4V battery consists of two cells, and the 11.1V battery consists of three cells. The voltage of a single cell should not be lower than 3.3V or higher than 4.2V. Store the device between 3.8-3.9V for extended periods.
Overheating of the motor may cause the battery to expand or even ignite. Please inspect your device carefully and use with caution. Do not use the battery if it is damaged or bulging.
If the battery does not fully charge after a long period of time, use a baby ring to check the voltage of each cell.
Remove the battery when not in use to extend the life of the transmitter.