UDL P320 14mm CCW Metal Adapter

说明：
此适配器重量轻；请勿用力拧紧，以免损坏！

适配器的螺纹分为正螺纹和反螺纹。正螺纹顺时针旋入，反螺纹逆时针旋入。买错螺纹会导致适配器无法正确安装或错位。请在购买前仔细检查，确保螺纹规格正确。

注意： 10mm螺纹适配器的壁厚比其他适配器要薄。这是因为10mm螺纹适配器中心中空，用于容纳7-8mm的夜光弹簧，所以壁厚无法再增加；这是唯一可能的厚度。如果壁厚增加，7-8mm的夜光子弹将无法穿过中心。使用时，请勿用力旋转，否则会导致适配器破裂！

兼容性：适用于 UDL P320 玩具枪。

M10螺纹外径为10毫米，
M11螺纹外径为111毫米，
M12螺纹外径为12毫米，
M13螺纹外径为13毫米，
M14螺纹外径为14毫米。

材质：金属

包装清单： 1 * 14mm CCW 金属适配器

We Promise

We offer free shipping and tax exemption worldwide. If you are unable to pay or have questions about the payment amount, please contact us.
If the product or accessory you want to buy is not shown on our website, please send us a message and we will solve it for you as soon as possible.
Secure payment via Shopify Payments or PayPal.
We use encrypted SSL certificates to ensure 100% security.
Customer service responds to messages 24 hours a day.
30-day money back guarantee.If you are not completely satisfied with the product for any reason, you can initiate a return within this period.
Based on past experience, 99% of packages pass through customs smoothly. If your package is unfortunately detained by customs, we will resend it or provide a full refund. We guarantee that our customers will not suffer any loss.
If you do not have a pleasant shopping experience, please contact us at service@akagtoy.com, we will provide you with satisfactory service and make you 100% satisfied.

Soaking Requirements: It is best to use purified water, and sufficient water is essential. Impure water will cause the gel balls to shrink, which can result in reduced range or even inability to shoot.
Soaking Time: Soak the gel balls for 4-6 hours to ensure full expansion.
How to Use: Before loading the gel ball into the magazine, drain the water first to prevent moisture from damaging the circuit.
Storage: After soaking, drain the water and store them tightly sealed. Gel balls that have been soaked for too long or not properly can break or get stuck, making them inoperable.
7-8mm super-hard frosted balls are best for electric pistol toys; other sizes break easily.
Standard Size: 7.15mm - 7.3mm (fits most gel blasters).

When using a battery for the first time, fully charge it. Do not charge the battery through the discharge port.
Use a charger with a voltage balancing function to charge the device.
If you notice a drop in power during use, discontinue use. Leave approximately 10% of the battery charge in the battery. Do not drain the battery completely to avoid damage caused by over-discharge.
For gel blasters with electronic speed control or fire control, remove the battery after use to avoid permanent damage.
Overheating of the motor may cause the battery to expand or even ignite. Please inspect your device carefully and use with caution. Do not use the battery if it is damaged or bulging.
Remove the battery when not in use to extend the life of the transmitter.